One-Dimensional Simulation of PM Deposition and Regeneration in Particulate Filters: Optimal Conditions for PM Oxidation in GPF Considering Oxygen Concentration and Temperature

This study presents a one-dimensional numerical simulation of particulate matter (PM) oxidation and regeneration behavior in gasoline particulate filters (GPFs) under Worldwide Harmonized Light Vehicles Test Cycle (WLTC) conditions. The model incorporates both catalyst activity—represented by activation energy (E) and pre-exponential factor (A)—and exhaust control strategies involving forced fuel cut (FC). PM deposition and oxidation were simulated based on solid-state and gas-phase reactions, with the effects of oxygen concentration and temperature analyzed in detail. The results show that under high catalyst activity (E = 100 kJ mol−1, A = 6.2 × 107), PM oxidation proceeds efficiently even during medium-speed phases, achieving a 98.8% oxidation rate after one WLTC. Conversely, conventional catalysts (E = 120 kJ mol−1, A = 6.2 × 106) exhibited limited regeneration, leaving 0.11 g of residual PM. Introducing forced FC effectively enhanced oxidation by increasing oxygen concentration to 20% and sustaining heat release. A single continuous 100 s FC yielded the highest oxidation (96% reduction), while split FCs reduced peak PM accumulation. These findings demonstrate that optimizing the balance between catalyst activity and FC control can significantly improve GPF regeneration performance, providing a practical strategy for PM reduction in GDI vehicles under real driving conditions.