Palladium Recovery from e-Waste Using Enterobacter oligotrophicus CCA6T

Palladium, a non-toxic platinum-group metal, is widely used in catalysis, electronics, hydrogen storage, and chemical industries because of its excellent physical and chemical properties. However, given that the number of palladium-producing countries is limited, recycling is considered essential for ensuring a stable and sustainable global supply. Here, I describe a simple and efficient method for palladium recovery from electronic waste (e-waste) using Enterobacter oligotrophicus CCA6T. To clarify biomineralization capacity, the role of electron donors in modulating biomineralization capacity was examined. Findings showed that formic acid was the most effective donor, enhancing the relative recovery rate to 44% compared to 23% without electron donors. Transmission electron microscopy analysis revealed palladium particles (1–10 nm) distributed across the cell wall, periplasmic space and cytoplasm, confirming active biomineralization rather than passive biosorption. Moreover, based on a comparison with the biomineralization mechanism of Escherichia coli, the biomineralization mechanism of E. oligotrophicus CCA6T was estimated . Reaction parameters were then optimized by testing the effects of formic acid concentration, reaction temperature, and reaction pH. Under optimized conditions, the relative recovery rate exceeded 99% within 6 h using 40 mg/L palladium. When this method was applied to a metal dissolution solution prepared from e-waste , a recovery rate of 94% was achieved from trace concentrations (36 µg/L), and palladium loss from bacteria after the palladium recovery test was negligible (<0.01%). Taken together, these results demonstrate that biomineralization using E. oligotrophicus CCA6T could potentially be applied to the recovery of palladium from e-waste, particularly for trace-level concentrations where conventional methods are ineffective.