Flexural Strength of Modern CAD/CAM Restoratives After Artificial Aging

Before clinical trials are initiated, studying the mechanical performance of modern CAD/CAM restorative materials exposed to aging conditions would provide insights on their performance in service. This study evaluated the impact of thermomechanical aging on various resin composite, ceramic, hybrid, and nano-filled resin composite materials after two polymerization modes. Specimens (3 × 4 × 14 mm3) were fabricated using (n = 12 per group) a universal composite (Filtek Supreme XTE photo-polymerized for either 40 s or 120 s per layer), hybrid ceramics (BRILLIANT Crios, GC Cerasmart, Lava Ultimate, VITA ENAMIC), glass ceramics (IPS e.max CAD, VITA Suprinity PC, Straumann n!ce), or feldspar ceramics (VITABLOCS Mark II, GC Initial LRF). In each group, half of the specimens underwent thermomechanical aging. A three-point bending test was applied to all specimens and the results were statistically analyzed (α = 0.05). Glass ceramics and hybrid ceramics presented higher flexural strength values than feldspar ceramics and the universal composite before and after aging (p < 0.05). Thermomechanical cycling affected the flexural strength of all materials (p < 0.05) except Lava Ultimate, Straumann n!ce, and GC Initial (p > 0.05). The highest decrease in flexural strength after aging was found in the universal composite (40 s polymerization) (p < 0.001) and Vita Enamic (p < 0.001), while the lowest decrease was in the hybrid ceramics, Cerasmart and Lava Ultimate (p < 0.05). Extending polymerization duration reduced the aging effect on the universal composite tested. Thermomechanical aging affected the flexural strength of most materials tested. Universal composites and feldspar ceramics presented similar flexural strength values.