The influence of water turbulence on surface deformations and the gas transfer rate across an air–water interface

We present experimental results of a study on oxygen transfer rates in a water channel facility with varying turbulence inflow conditions set by an active grid. We compare the change in gas transfer rate with different turbulence characteristics of the flow set by four different water channel and grid configurations. It was found that the change in gas transfer rate correlates best with the turbulence intensity in the vertical direction. The most turbulent cases increased the gas transfer rate by 30% compared to the low turbulence reference case. Between the two most turbulent cases studied here, the streamwise turbulence and largest length scales in the flow change, while the gas transfer rate is relatively unchanged. In contrast, for the two less turbulent cases where the magnitude of the fluctuations normal to the free surface are also smaller, the gas transfer rate is significantly reduced. Since the air–water interface plays an important role in the gas transfer process, special attention is given to the free-surface deformations. Despite taking measures to minimise it, the active grid also leaves a direct imprint on the free surface, and the majority of the waves on the surface originate from the grid itself. Surface deformations were, however, ruled out as a main driver for the increase in gas transfer because the increase in surface area is < 0.25%, which is two orders of magnitude smaller than the measured change in the gas transfer rate.