Rheological control of cementitious composites incorporating ceramic wastes for 3D printing applications

In response to the environmental impact of cement production and industrial discarded materials, this study explores the valorisation of ceramic wastes as replacement of clinker in low-carbon cementitious composites for application in additive manufacturing. Ceramic wastes from different sources were used as substitute of calcined clay in limestone calcined clay cement (LC3) mortar. The embodied CO 2 reduction of these new binders exceeds 40 % compared to Portland Cement (PC), thus representing a notable advancement in low-emission cementitious composites. The influence of six ceramic wastes on the fresh state performance of mortar was assessed through flow table tests and rheological measurements. A ball measuring system was used to assess viscosity, static yield stress, and their early-age evolution, combining the high resolution of benchtop rheometers with the possibility of testing of 3D-printable mortars with aggregates up to 2 mm, featuring high yield stress values. Numerical simulations based on the Particle Finite Element Method were then used to evaluate the printability of developed mix designs, avoiding time consuming trial and error testing campaigns and paving the way for through printing trials on a selected set of waste materials. Numerical simulations highlighted that, while all tested formulations showed good performance for small-scale 3D printing, careful material selection becomes crucial when targeting larger structures to ensure stability and minimize deformation. Additionally, the simulations allowed prediction of material behaviour, particularly valuable given the high variability of waste-based constituents, emphasizing the innovative combination of circular economy concepts with a unique approach to additive manufacturing supported by numerical simulations. • Ceramic wastes replaced calcined clay in LC3, cutting CO 2 by more than 40 %. • Rheology of six wastes-mixes was assessed by flow table and ball measuring system. • Viscosity, static yield stress, and thixotropy index were quantified. • PFEM simulations predicted printability and guided 3D-printing trials. • Careful material selection is crucial to enable additive manufacturing.