Numerical Simulation Study on Fire Resistance Performance of Prefabricated Shear Walls Connected by Sleeve Grouting

As a critical element within the prefabricated structural system, the prefabricated shear wall connected by sleeve grouting is renowned for its superior mechanical performance and high construction efficiency. It is widely applied in mid- and high-rise buildings. However, under fire conditions, not only do the material properties degrade, but the structural connections may also fail, significantly compromising the structural stability and safety. Therefore, this study delves into the fire resistance performance of such prefabricated shear walls. The research primarily focuses on analyzing fire resistance characteristics, including deformation patterns, lateral and axial deformations, fire resistance limits, and other performance metrics, for both prefabricated and cast-in-place shear walls subjected to three hours of single-sided fire exposure. Additionally, a parametric analysis is performed. The results reveal that, after three hours of single-sided fire exposure, the temperature distribution patterns at the mid-width and mid-height sections of the prefabricated shear wall generally resemble those of the cast-in-place wall, displaying arch-shaped and strip-shaped distributions, respectively. However, due to the presence of sleeves, higher temperatures are observed near the sleeve areas in the prefabricated wall, along with a more extensive high-temperature zone. Throughout the three-hour fire exposure, both types of shear walls demonstrated satisfactory structural stability and thermal insulation performance, meeting the requirements for a first-level fire resistance rating (3 h). Nevertheless, greater axial and lateral deformations were noted in the prefabricated shear wall. Key factors influencing the fire resistance performance of the sleeve-connected prefabricated shear wall include the axial compression ratio, longitudinal reinforcement diameter, protective layer thickness, and height-to-thickness ratio. Specifically, axial deformation is found to be directly proportional to the axial compression ratio and height-to-thickness ratio, while inversely proportional to the longitudinal reinforcement diameter and protective layer thickness. Lateral deformation is directly proportional to the axial compression ratio and longitudinal reinforcement diameter, and exhibits a trend of initially increasing and then decreasing with an increase in protective layer thickness, and initially decreasing and then increasing with an increase in the height-to-thickness ratio.