Effect of multiple calcination cycles on CO2 capture efficiency during carbonation of MgO in a mineral looping process

Magnesium oxide (MgO) is considered as a potential sorbent for direct air capture of carbon dioxide in a looping process. Previous research on mineral looping for carbon capture from flue gas using MgO has shown deactivation of the sorbent with repeated cycles but repeated cycling for carbonation at ambient conditions has not been yet investigated. Here, we tested three cycles of carbonation for MgO nano-scale powders with different starting surface area. We find that carbonation efficiency is higher at higher surface area. No decrease in carbonation efficiency was observed with cycling, instead we find that carbonation efficiency and surface area are stable or even increasing with cycling. Based on our experimental data, we hypothesize that the carbonation in presence of relative humidity leads to first hydration of MgO, leading to formation of brucite (Mg(OH)₂). This formation of Mg(OH)₂ is a volume-increasing reaction, which leads to fracturing of MgO particles and results in an increase in surface area. We observed formation of amorphous and crystalline hydrated carbonates. The crystalline phase observed was nesquehonite (MgCO₃ ⋅ 3H₂O). Our results show that MgO does not show any deactivation with repeated cycling for carbon capture at ambient conditions and in the presence of humidity. These findings therefore indicate that MgO is a suitable candidate as sorbent material for direct air capture of carbon dioxide.