Optimal sizing and material choice for additively manufactured compact plate heat exchangers
Axial wall conduction can limit the compactness of counterflow heat exchangers, making material selection dependent on both thermal conductivity and achievable wall thickness. This study investigates how additive manufacturing (AM) limits influence the optimal sizing and thermal power density of compact parallel-plate heat exchangers. A nondimensional analytical model accounting for lateral and axial wall conduction is coupled with geometric optimization for six materials: plastic, austenitic steel, aluminum oxide, aluminum nitride, aluminum and copper. Channel length and spacing are optimized at prescribed pressure drop and effectiveness, considering uniform or material-specific wall thicknesses and a minimum-spacing constraint. The effects of target effectiveness and improvements in thin-wall manufacturing are also examined. With a common wall thickness and minimum spacing, plastic and austenitic steel achieve similar calculated power densities. Under the selected material-specific thickness limits and minimum-spacing constraint, plastic reaches approximately 7.5 times the power density of copper. Its optimized design also achieves approximately 52% higher power density than the corresponding fixed-spacing reference with the same wall thickness. High-conductivity materials require larger channel dimensions to limit axial conduction losses, particularly at high effectiveness. Reducing wall thickness provides the greatest improvement for copper over the investigated thickness ranges, while thinner austenitic steel becomes competitive with plastic at lower effectiveness targets. These findings demonstrate the importance of jointly selecting material, wall thickness and channel geometry, and identify how improvements in AM thin-wall capability can influence achievable heat exchanger compactness.
Authors
- Martine Baelmans (ORCID: https://orcid.org/0000-0001-9905-4583)
- Maarten Blommaert (ORCID: https://orcid.org/0000-0002-2616-8042)
- Frederik Rogiers (ORCID: https://orcid.org/0000-0002-9777-6301)
Institutions
- KU Leuven (BE)
Publication Details
- Journal
- Thermal Science and Engineering Progress
- Published
- 2026-11-16
- DOI
- https://doi.org/10.1016/j.tsep.2026.105004
- Primary Topic
- Heat Transfer and Optimization
- Type
- article
- Field-Weighted Citation Impact
- 0.00
Funders
- Agentschap Innoveren en Ondernemen
- KU Leuven