A Multi-Analytical Study of Nanolignin/Methylcellulose-Coated Groundwood and Cotton Linter Model Papers

This paper presents the synthesis of sustainable lignin nanoparticles (LNPs) and their application in methylcellulose (MC) as LNP/MC coatings for handmade papers. LNPs were produced from bulk kraft lignin via an acetone/water and sonication method, then incorporated into a 1 wt% methylcellulose (MC) matrix at concentrations of 0.4, 1, and 2 wt%. Groundwood and cotton linter papers were coated and exposed to 90 °C and 45% relative humidity (RH) for 16 days and the samples' response to ageing at different concentrations of nanolignin was tested using a multi-analytical approach. The morphology of the LNPs was revealed with scanning electron microscopy, and most LNPs measured below a diameter of 30.8 nm. Colourimetry showed coated samples were inherently darker than uncoated samples but mostly stable in colour. pH remained near neutral for coated groundwood papers during ageing, but cotton papers were consistently acidic. Fourier transform infrared (FTIR) spectroscopy identified spectral similarities between uncoated and coated groundwood samples at approximately 1635 cm^-1 and 1725 cm^-1, attributed to carbonyl and carboxyl groups, suggesting that LNPs did not contribute to the formation of these groups during ageing. Controlled environment dynamic mechanical analysis (DMA-RH) found improved consolidation and lower elongation in most LNP/MC-treated samples. These results indicate that there may be potential for LNPs within paper conservation.