Research on the Lubrication and Friction Characteristics of New Water-Lubricated Bearings Made of PEEK Material in Salt-Sand Water Environments

During the actual service process, water-lubricated bearings on ships are often in complex operating environments such as low speed, heavy load and salt-sand water areas. To meet the requirements of high load-bearing capacity, long service life and the ability to discharge sand and dissipate heat during the service of bearings, research has been conducted on water-lubricated bearings made of polyetheretherketone (PEEK) with a semi-groove structure. Mathematical and physical models based on the averaged Reynolds equation have been established. By adopting the method of multi-physics field coupling, the lubrication characteristics of the bearings under the coupling influence of multiple factors in the salt-sand water environment (lubrication interface (the surface roughness of the bearing bush), different working conditions (water supply pressure, rotational speed, eccentricity)) are analyzed. Finally, a water-lubricated bearing test bench is set up to conduct bearing lubrication performance tests under multiple factors. The research shows that compared with liquid water, the salt-sand water environment exhibits better lubrication characteristics. The maximum water film pressure, the deformation amount of the bearing bush and the bearing capacity of the bearings increase with the increase of the rotational speed, water supply pressure and eccentricity, while the friction coefficient decreases. With the increase of the roughness of the bearing bush, these parameters decrease slightly and the friction coefficient increases. The presence of salt-sand particles can weaken the influence of roughness on the lubrication characteristics of the bearings. After considering the thermal effect, the mechanical load and thermal load act on the surface of the bearing bush together, resulting in an increase in the deformation amount of the bearing bush, a 0.11% drop in the water film pressure, and the highest temperature of the water film being concentrated at the outlet of the groove. The local semi-groove structure of PEEK can make the friction coefficient as low as 0.019. The comparison errors between the simulation and the experiment are within 10% (for water film pressure) and 2.6% (for friction coefficient), which verifies the reliability of the model.