Exceptional NH <sub>3</sub> Detection by Cu(cyhdc) MOF Sensor Due to H <sub>2</sub> O Coadsorption
Metal-organic framework (MOF)-based electrical impedance sensors are a growing class of sensors that show utility in the detection of environmentally toxic gases. Detection of trace NH<sub>3</sub> has been particularly difficult to design due to the low electrical response of NH<sub>3</sub>. However, this has been circumvented by judiciously selecting a MOF that has enhanced electrical response to NH<sub>3</sub> due to coadsorption with predominant atmospheric gases such as water. Herein, an MOF Cu(cyhdc) based sensor has been successfully demonstrated for the enhanced detection of environmentally toxic NH<sub>3</sub> gas. The sensor shows a change in impedance when it is exposed to 5 ppm of NH<sub>3</sub>. At 20 °C, >30% relative humidity (RH) is necessary to elicit a change, with the response increasing with RH and reaching 3170× at 92% RH, producing the largest published response to NH<sub>3</sub> for a MOF direct electrical sensor. In the absence of water, no change is observed toward 5 ppm of NH<sub>3</sub> over 20-50 °C. This electrical response is largely driven by huge decreases in the imaginary component of the impedance, attributed to increased capacitance at the surface of the MOF crystallites upon NH<sub>3</sub> and H<sub>2</sub>O coadsorption. Complementary structural and microstructural characterization proves that the Cu(cyhdc) crystalline structure and morphology remain intact under trace NH<sub>3</sub> and/or H<sub>2</sub>O adsorption. Despite extremely low NH<sub>3</sub>, loadings seen in TGA, XPS, and FT-IR confirm NH<sub>3</sub> and H<sub>2</sub>O adsorption, and changes to the metal-carboxylate IR peak positions are observed upon NH<sub>3</sub> adsorption. Concentrated primarily at the outer surfaces of the MOF crystallites, this NH<sub>3</sub> and H<sub>2</sub>O coadsorption effectively increases the surface capacitance across the Cu(cyhdc) powder and enables direct electrical detection of trace NH<sub>3</sub>. Together, these results demonstrate how coadsorption of specific molecules (H<sub>2</sub>O) can be used to enable the electrical detection of trace toxic gases that would otherwise not have produced a MOF sensor response.
Authors
- Tina M. Nenoff (ORCID: https://orcid.org/0000-0002-7906-4810)
- Leo J. Small (ORCID: https://orcid.org/0000-0003-0404-6287)
- Stephen J. Percival (ORCID: https://orcid.org/0000-0003-2067-7468)
- Matthew J. Hurlock (ORCID: https://orcid.org/0000-0002-0262-2095)
- David Rademacher (ORCID: https://orcid.org/0000-0003-0198-8519)
- Melissa Meyerson (ORCID: https://orcid.org/0000-0001-9327-442X)
- Mara Schindelholz (ORCID: https://orcid.org/0000-0002-0672-9674)
- Michael E. Ureña (ORCID: https://orcid.org/0009-0002-5212-0197)
Institutions
- Sandia National Laboratories (US)
Publication Details
- Journal
- ACS Applied Materials & Interfaces
- Published
- 2025-10-08
- DOI
- https://doi.org/10.1021/acsami.5c13480
- Primary Topic
- Gas Sensing Nanomaterials and Sensors
- Type
- article
- Field-Weighted Citation Impact
- 0.00