Enhancing forest air sampling using a novel reusable ozone filter design

Abstract. Biogenic volatile organic compounds (BVOCs), such as monoterpenes, play essential roles in ecological and atmospheric processes, influencing air quality, climate, and interspecies interactions. For accurate identification and quantification of these reactive compounds in the environment, active sampling on sorbent tubes followed by thermal desorption–gas chromatography–mass spectrometry is commonly used. However, ozone present in the sampled air can degrade both the analytes and the sorbent material during the sampling process, leading to underestimation of target substances and overestimation of their degradation products. This study evaluates a novel reusable ozone filter designed for direct attachment to sorbent tubes and compatibility with multi-tube samplers. The filter utilizes potassium iodide (KI) or sodium thiosulfate (Na2S2O3) deposited on reusable glass filters and copper wool to improve the accuracy of BVOC measurements. Both types of ozone scrubbers were tested under varying ozone concentrations up to 50 ppb and relative humidity levels up to 90 %, utilizing a straightforward load-and-flush method as well as a permeation approach that simulates field sampling conditions. Furthermore, both methods were compared regarding their suitability for the systematic evaluation of ozone filters. Results indicate that both KI and Na2S2O3 effectively remove ozone, with KI showing a slightly higher performance and lower dependence on relative humidity, maintaining over 90 % removal efficiency even after 10 d of ambient air exposure. Recovery rates for four structurally different monoterpenes (α-pinene, myrcene, limonene, linalool) showed no significant differences between filtered and unfiltered samples at baseline ozone concentrations, demonstrating that the ozone filters did not negatively impact analyte recovery. When no filter was used, recovery rates for myrcene, limonene, and linalool declined with increasing ozone concentration while showing a method-dependent positive influence of increasing relative humidity. Both scrubber materials maintained high and comparable recovery rates across all tested conditions, except at very low relative humidity, thereby enhancing measurement accuracy and comparability under diverse environmental scenarios. Field tests confirmed the effectiveness of KI-loaded scrubbers in enhancing monoterpene detection in forest air while safeguarding the sorbent material. These results, combined with the easy reusability of the glass filters and the absence of additional equipment or power requirements, highlight that this scrubber design proves to be an optimal choice for the long-term environmental monitoring of volatile organic compounds.