Evaluation of Temperature- and Salt-Resistant Foam Acid and Study of Foam Diversion Mechanism

Foam acidification is often employed as a clean and efficient method to remove blockages from wells and promote oil and gas production. In order to effectively control the diffusion of H+ in the acid solution into the rock surface, reduce the acid–rock reaction rate, and achieve deep acidification, a foam-retarding acid with foam stability, temperature and salt resistance, and excellent retarding performance was prepared by studying the synergistic effect of the foaming agent and foam stabilizer. ZG-A was used as the foaming agent, and ZG-B was added as a foam stabilizer to achieve foam stabilization. When the ZG-A/ZG-B ratio was 0.67%/0.33%, the foam exhibited the best comprehensive performance. By measuring and comparing the acid–rock reaction rate under different conditions, the results showed that the average acid–rock reaction rate of the 10% compound acid was 1.412 × 10−3 mg/(cm2·s), while the average acid–rock reaction rate of the foam-retarding acid system was reduced to 6.622 × 10−5 mg/(cm2·s), representing a reduction of two orders of magnitude, and the slow rate reached 95.31%. Foam fluid diversion experiments were carried out on cores with different permeabilities. The results showed that the foam could increase the diversion flow rate of low-permeability cores and reduce the diversion flow rate of high-permeability cores. Thus, the foam fluid could be uniformly propelled in cores with different permeabilities. Based on this principle, foam acid acidification can increase the amount of acid injection into the low-permeability layer and reduce the amount of acid absorption in the high-permeability layer, thereby improving the acidification effect.