Quantum Ghost Imaging of Remote Targets With Novel SPAD Technology

Low-light-level imaging in the infrared regime could find applications in areas ranging from technological to biological. Still, its development is limited by the inefficiency of silicon-based detectors in this regime. Quantum Ghost Imaging (QGI) can address this limitation by allowing the separation of illumination and imaging [1]. This is accomplished by generating non-degenerate correlated photon pairs, whose infrared photon probes the object and is detected by an InGaAs bucket detector, while the spatial distribution of the visible one is collected by a single-photon sensitive silicon camera. Traditional QGI setups evaluate photon correlations through “heralding”, by triggering the camera upon idler detection and thus require an image-preserving delay-line, which limits their use for remote sensing [1]. In asynchronous QGI (aQGI) cameras are replaced with SPAD arrays [2] able to record photon timestamp with picoseconds precision. By identifying pairs through timestamps comparison, the mentioned limitations are resolved [3], enabling applications with reflective or diffusive objects where the timestamp delay depends on the object's position. In this work, we propose and demonstrate an experimental QGI setup for remote sensing in reflection configuration (Fig. 1). Collinear non-degenerate pairs of single-photons at 550 nm and 1550 nm are generated by pumping a 2 mm-long type-0 ppKTP crystal with a 405 nm laser. To enable imaging of objects at varying distances, we implemented a momentum-correlation-based setup. Infrared photons interacting with the object were collected by commercially available InGaAs SPAD detectors, while the visible photons were directly captured using a prototype silicon SPAD array developed by Politecnico di Milano [4]. It is based on a 32×32 SPAD, with in-pixel TDCs, and on-chip microlenses are employed to reach a fill factor of 78%. The time resolution is adjustable down to 250 ps, with 1 μs Full Scale Range (FSR). The measurement duty cycle (i.e. the ration of the TDC FSR and the frame time) can be increased with a multi-gate acquisition scheme. To validate the efficiency of our setup, we tested it using a proof-of-principle object, as shown in Fig. 1b. The reconstructed images, captured with the object placed at 30 cm intervals in an acquisition time of only 30 s, are shown in Fig. 1c. In summary, the shown results confirm the potential of the proposed setup for remote sensing applications, particularly for reflective or diffusive objects. Moreover, the proposed approach could offers the possibility of significantly reduce acquisition times compared to standard QGI setups.