Study on Laser Drilling of Micro-Holes Using a Breakthrough Detection Method

Achieving high efficiency and quality in millisecond pulsed laser drilling of metallic through-holes is contingent on precise process control. This study introduces a penetration detection-based method to determine the pulse count threshold, effectively overcoming the limitations of conventional approaches. We systematically investigated the effects of pulse energy, defocus, and beam expansion ratio on the drilling of 3 mm thick 304 stainless steel and TC4 titanium alloy. The experiments revealed that for stainless steel 304, the minimum taper angle was achieved at a pulse energy of 2.2 J, a defocus amount of -0.5 mm, and a beam expansion ratio of 2.5. Additionally, relatively high drilling efficiency was observed when the pulse energy ranged from 2.6 to 2.8 J, the defocus amount was -1 to 0 mm, and the beam expansion ratio was 3 to 4. For titanium alloy TC4, the minimum taper angle was achieved at a pulse energy of 2.6 J, a defocus amount of -0.5 mm, and a beam expansion ratio of 3.5. High drilling efficiency was recorded when the pulse energy was 2.8 J, the defocus amount was -0.5 mm, and the beam expansion ratio ranged from 2.5 to 3. When stainless steel 304 and titanium alloy TC4 were processed using the same laser parameters, the drilling efficiency of stainless steel 304 was higher than that of titanium alloy TC4 under the same conditions. This work provides a practical process control strategy and a valuable parameter database for high-quality, efficient laser drilling of these industrially important metals.