Improving offloading in diabetic feet: 3D-printed custom accommodative insoles outperform standard of care
Introduction 3D-printed custom accommodative insoles may offer improved plantar pressure offloading compared to standard-of-care (total contact EVA base with a 4-mm Plastazote-PORON foam top layer) insoles for individuals with diabetes. We have developed two versions of 3D-printed accommodative insoles that have patient-specific geometries as well as patient-specific stiffnesses and structural behaviors. The purpose of this study is to determine if two styles of novel 3D printed accommodative insoles (pressure-based and finite element-based), with patient-specific geometries as well as local patient-specific stiffnesses, can provide greater reductions in plantar pressures for at-risk areas of the foot without increasing pressure in the regions adjacent compared to the standard-of-care and no insole, in individuals with diabetes. Methods Twenty-five adults with diabetes and high plantar pressure completed walking trials under no insole, standard-of-care, pressure-based insole, and finite element-based insole conditions. Peak plantar pressure and pressure-time integral were measured in high-risk regions of interest and adjacent regions. Participant comfort and preference were recorded. Results All insoles significantly reduced peak plantar pressure and pressure-time integral by greater than 14% in the regions of interest compared to no insole (p < 0.001). Compared with the standard-of-care, pressure-based insole and finite element-based insole further reduced peak pressure (22% and 24%, respectively) and pressure-time integral (19% and 35%, respectively) in the region of interest (p < 0.001). Finite element-based insole reduced pressure-time integral and peak plantar pressure in adjacent regions (p < 0.01), indicating broader offloading. Participant preferences and feedback indicated improvements in fit and comfort are needed across all insoles before clinical implementation. Conclusion There is potential for personalized, 3D-printed custom accommodative insoles as a patient-centered approach to offloading plantar pressure in individuals with diabetes. These technologies may support more effective and tailored strategies in preventing diabetic foot complications.
Authors
- William R. Ledoux (ORCID: https://orcid.org/0000-0003-4982-7714)
- Brittney C. Muir (ORCID: https://orcid.org/0000-0002-0978-5524)
- Mathew Sunil Varre (ORCID: https://orcid.org/0000-0003-1890-3956)
- Scott Telfer (ORCID: https://orcid.org/0000-0002-0104-4027)
- Ellen Y. Li (ORCID: https://orcid.org/0000-0001-5545-7364)
- Kimberly A. Nickerson (ORCID: https://orcid.org/0000-0001-9044-0808)
- Christina Carranza
- Dylan Jon Heino
- Avocet Y. Nagle-Christensen (ORCID: https://orcid.org/0009-0000-8873-2369)
Institutions
- University of Washington (US)
- VA Puget Sound Health Care System (US)
Publication Details
- Journal
- PLoS ONE
- Published
- 2026-11-19
- DOI
- https://doi.org/10.1371/journal.pone.0363325
- Citations
- 6
- Primary Topic
- Diabetic Foot Ulcer Assessment and Management
- Type
- article
- Field-Weighted Citation Impact
- 13.52
Funders
- U.S. Department of Veterans Affairs