Sensitive integrated photonic transducer with predictive modeling for underwater ultrasound sensing

A high signal-to-noise ratio (SNR) is critical for sensitive ultrasound applications. Unlike traditional piezoelectric sensors that rely on material properties, an integrated photonic ultrasound transducer (IPUT) separates sensing and read-out systems, allowing for better optimization. Here we use a silicon Mach-Zehnder interferometer (MZI) embedded in a circular silicon dioxide membrane, where incident acoustic pressure modulates the optical phase. We extend the semi-analytical model introduced in our previous work to incorporate the device geometry and fabrication-induced internal stress, enabling accurate prediction of the transducer's optomechanical response. This approach resulted in an experimentally measured sensitivity of 0.47 pm/Pa at a resonance frequency near 1 MHz, in close agreement with the model prediction of 0.46 pm/Pa. This performance represents a sevenfold improvement over previously reported devices [Lienders et al., Sci. Rep., 2015]. Additionally, we have developed two more IPUTs where multiple membranes were cascaded and their performance was experimentally investigated. The IPUT with three membranes had an RTF of 1.4 pm/Pa, while the IPUT with five membranes' RTF was 2.24 pm/Pa. Our IPUTs also have excellent noise performance, as demonstrated by the noise equivalent pressure (NEP) of the device. NEP of IPUT with one membrane is 42.5 mPa, IPUT with three membranes is 15.5 mPa, and the IPUT with five membranes is 14.2 mPa. Compared to the state-of-the-art ultrasound sensors, our IPUT with five membrane shows 35 times lower NEP. Our results demonstrate that fabrication-aware modeling is crucial for achieving optimal sensitivity in IPUTs, establishing the proposed IPUT as a promising solution for underwater ultrasound sensing.