Research on Quantitative Analysis Method of Infrared Spectroscopy for Coal Mine Gases

Accurate and reliable detection of coal mine gases is the key to ensuring the safe service of coal mine production. Fourier Transform Infrared (FTIR) spectroscopy, due to its high sensitivity, non-destructive nature, and potential for online monitoring, has emerged as a key technique in gas detection. However, the complex underground environment often causes baseline drift in IR spectra. Furthermore, the variety of gas species and uneven distribution of concentrations make it difficult to achieve precise and reliable online analysis using existing quantitative methods. This paper aims to perform a quantitative analysis of coal mine gases by FTIR. It utilized the adaptive smoothness parameter penalized least squares method to correct the drifted spectra. Subsequently, based on the infrared spectral distribution characteristics of coal mine gases, they could be classified into gases with mutually distinct absorption peaks and gases with overlapping absorption peaks. For gases with distinct absorption peaks, three spectral lines, including the absorption peak and its adjacent troughs, were selected for quantitative analysis. Spline fitting, polynomial fitting, and other curve fitting methods are used to establish a functional relationship between characteristic parameters and gas concentration. For gases with overlapping absorption peaks, a wavelength selection method bassed on the impact values of variables and population analysis was applied to select variables from the spectral data. The selected variables were then used as input features for building a model with a backpropagation (BP) neural network. Finally, the proposed method was validated using standard gases. Experimental results show detection limits of 0.5 ppm for CH₄, 1 ppm for C₂H₆, 0.5 ppm for C₃H₈, 0.5 ppm for n-C₄H₁₀, 0.5 ppm for i-C₄H₁₀, 0.5 ppm for C₂H₄, 0.2 ppm for C₂H₂, 0.5 ppm for C₃H₆, 1 ppm for CO, 0.5 ppm for CO₂, and 0.1 ppm for SF₆, with quantification limits below 10 ppm for all gases. Experimental results show that the absolute error is less than 0.3% of the full scale (F.S.) and the relative error is within 10%. These results demonstrate that the proposed infrared spectral quantitative analysis method can effectively analyze mine gases and achieve good predictive performance.