The Influence of Coagulation on the Fertilizing Properties of Treated Wastewater

Treated wastewater (TW) is a valuable source of water for plant irrigation, helping to protect water resources. However, to use it, a preliminary treatment is necessary, typically involving coagulation to reduce turbidity and then disinfection to ensure microbiological safety. The aim of this research was to determine changes in the concentrations of basic fertilizer components (N, P, and K) in TW after the coagulation process. The tests were carried out in three measurement series for volumetric and surface coagulation using three coagulants: Al2(SO4)3, PAX-XL 19F, and PAX-XL 1911. Four doses of aluminum were used for each coagulation method (volumetric coagulation: 1, 2, 4, and 8 mg Al/L; surface coagulation: 0.25, 0.5, 1, and 2 mg Al/L). Studies have shown that despite the reduction in the concentration of nutrients during the coagulation process, the reclaimed water used for grass irrigation would cover the entire K requirement of this plant. In the case of N and P, the demand would be covered by 14.34% and 8.55%, depending on the coagulant used and its dose. It was also documented that the type of coagulant significantly influences the reduction of fertilizing properties during wastewater treatment. PAX-XL19F was found to cause the least reduction in P and K concentrations, while Al2(SO4)3 had the least negative impact on N regardless of coagulation method or dose.