Hot Isostatic Pressing Synthesis of Al-Ta Energetic Structural Material Based on Modified Drucker–Prager Cap Model

The Al-Ta energetic structural material (ESM) has significant potential for applications in energetic fragments. To rationally design the hot isostatic pressing (HIP) process for Al-Ta, this paper developed a novel parameter identification method for the modified Drucker–Prager Cap (DPC) model. The identified parameters were subsequently applied to simulate the densification behavior of Al/Ta mixed powders during HIP. Based on the simulation results, the HIP process parameters for fabricating the Al-Ta ESM were determined. Meanwhile, the microstructure, mechanical properties, and impact-induced reaction characteristics of the HIP-fabricated Al-Ta ESM were further analyzed. The main results are as follows. The comparison between the HIP simulations and experiments revealed good agreement, confirming the high accuracy of the identification of the modified DPC model parameters. In addition, the Al-Ta ESM fabricated via HIP at 460 °C/140 MPa/2 h exhibits a dense microstructure and enhanced mechanical properties. Furthermore, it demonstrates effective damage performance during the penetration of double-layered targets.