Experimental Study on Punching Shear Behavior of Ultra-High-Performance Concrete (UHPC) Slabs

This study assesses the punching shear characteristics of ultra-high-performance concrete (UHPC) slabs in two phases. The initial phase involved experimental tests to determine the critical thickness differentiating punching shear failure and flexural failure modes. Subsequently, the second phase further explored the punching shear behavior of UHPC slabs by analyzing various key parameters. The experimental findings indicated that as the thickness of the slabs increased, the punching shear capacity exhibited nearly linear enhancement, surpassing the improvement seen in bending capacity. Thus, a critical thickness of at least 100 mm was identified as the threshold distinguishing punching shear failure from flexural failure. Additionally, an increase in slab thickness significantly elevated the cracking load of the UHPC slabs. While a higher reinforcement ratio of 3.5% slightly increased the first cracking load, it greatly enhanced the ultimate capacity. The addition of steel fibers also contributed to improvements in both cracking and ultimate loads, albeit to a limited extent. The use of a granite powder substitute, comprising 10% of the mass of silica fume, had minimal impact on the punching shear capacity of the UHPC slabs. Finally, a comparison is drawn between the experimental results for punching shear capacity and those obtained from various theoretical models. This comparison highlights significant discrepancies in the results, stemming from the differing parameters employed in the proposed theoretical models. Among the prediction models, the JSCE model provided the most balanced and conservatively accurate estimation of punching shear capacity, effectively incorporating the effects of slab thickness, reinforcement ratio, and fiber content, thus highlighting its potential as a reliable reference for future design recommendations. This information will serve as a valuable reference for future research and practical applications related to UHPC bridge decks and slabs.