A Soft Variable Stiffness Actuator with a Chain Mail Structure as a Particle Jamming Interface

Variable stiffness actuators (VSAs) have attracted considerable attention in wearable robotics and soft exoskeletons due to their ability to adapt to various load conditions. This study presents a modular design for VSAs that incorporates a chain mail structure with various link topologies, allowing for a reconfiguration of stiffness. The proposed VSA consists of three main parts: the vacuum chamber, the VSA actuator, and the chain mail structure. The VSA fabrication process was carried out in five stages: (1) mold fabrication by 3D FDM printing, incorporating a film of oil to facilitate easy demolding; (2) mold preparation using silicone, with a precise ratio of 1:1 weight-based mixture to optimize material utilization; (3) silicone pouring into molds while applying vibration to eliminate air bubbles; (4) curing for four hours to achieve optimal mechanical properties; and (5) careful demolding to prevent damage. Experimental tests were conducted to characterize the stiffness of actuators with different chain mail fabric configurations, using an experimental setup designed to securely fix the actuator and accurately measure the pneumatic pressure and the angle of deformation after applying weights at its end. The European 6-in-1 and rounded square configurations were shown to be the most effective, increasing stiffness up to 382% compared to the chain mail-free configuration, highlighting the positive impact of these structural designs.