From Waste to Catalyst: The Properties of Mixed Oxides Derived from Layered Double Hydroxide Mg/Al Synthesized from Aluminum Residues and Their Use in Transesterification

Mixed oxides were obtained via calcination at 550 °C from layered double hydroxides (LDHs), which were synthesized in a previous study via co-precipitation and co-precipitation followed by hydrothermal treatment using aluminum residues as the source of this element. After characterization, these oxides (Mg-Al-LDH-CP and Mg-Al-LDH-H, named according to the synthesis methods of the precursor LDHs) were applied as heterogeneous catalysts in the methyl transesterification of ethyl acetate (EA). The formation of mixed oxides was confirmed by the absence of basal peaks associated with the layered LDH structure in the XRD analysis, due to calcination. Further characterization revealed that Mg-Al-LDH-CP exhibited the highest number of acidic sites, while Mg-Al-LDH-H had the highest number of basic sites. The transesterification activity was evaluated in the reaction between ethyl acetate (EA) and methanol (MeOH). The best result, obtained under a molar ratio of 1:5:0.005 (EA:MeOH:catalyst) at 120 °C, was a 63% conversion after 360 min of reaction for the Mg-Al-LDH-CP catalyst, which had a higher number of acidic sites and fewer basic sites. Additionally, the catalysts demonstrated robustness, maintaining catalytic activity over four cycles without a significant decrease in performance. These results indicate the feasibility of using mixed oxides derived from LDH, synthesized from aluminum residues, as heterogeneous catalysts in transesterification reactions, highlighting their potential for advancing more sustainable catalyst development.