Joint Transmit and Receive Beamforming Design for a Full Duplex UAV Sensing Network

Unmanned aerial vehicles (UAVs) are promising and powerful aerial platforms that can execute a variety of complex tasks. However, the increasing complexity of tasks and number of UAV nodes pose significant challenges for UAV sensing networks, such as limiting the spectral resources and increasing device complexity. A potential solution is to implement full-duplex (FD) technology in UAV sensor network transceivers. Although appropriate self-interference (SI) cancellation techniques have been employed in the digital domain, the amplitude of the signal of interest (SoI) is relatively small and can be obscured by SI, especially over longer distances. Moreover, the introduction of phase offsets when filtering measurement signals can lead to signal distortion, resulting in estimation errors in the measurement results. To address these issues, this paper presents a joint transmit (TX) and receive (RX) beamforming algorithm based on the penalty dual decomposition (PDD) algorithm, which considers the constraints of transmission power, reception power, and residual SI power. The simulation analyses demonstrate that with a limited number of antennas, the proposed joint TX-RX beamforming algorithm can effectively suppress SI by up to 140 dB, yielding high-precision measurements in UAV sensor networks without compromising the accuracy of the control signals. Compared with that of the traditional frequency-division duplex (FDD) mode, the measurement accuracy is not decreased; compared with those of the time-division duplex (TDD) mode, the distance and speed measurement accuracies of the UAVs are increased by 10 m and 1.5 m/s, respectively, in the FD mode because there is no interruption of the tracking loop and no continuous retracking in the FD mode.