Surface-Dependent Meteorological Responses to a Taklimakan Dust Event During Summer near the Northern Slope of the Tibetan Plateau

The northern slope of the Tibetan Plateau (TP) is the crucial affected area for dust originating from the Taklimakan Desert (TD). However, few studies have focused on the meteorological element responses to TD dust over different surface types near the TP. Satellite data and the Weather Research and Forecasting model coupled with chemistry (WRF-Chem) were used to analyze the dust being transported from the TD to the TP and its effect from 30 July to 2 August 2016. In the TD, the middle-upper dust layer weakened the solar radiation reaching the lower dust layer, which reduced the temperature within the planetary boundary layer (PBL) during daytime. At night, the dust’s thermal preservation effect increased temperatures within the PBL and decreased temperatures at approximately 0.5 to 2.5 km above PBL. In the TP without snow cover, dust concentration was one-fifth of the TD, while the cooling layer intensity was comparable to the TD. However, within the PBL, the lower concentration and thickness of dust allowed dust to heat atmospheric continuously throughout the day. In the TP with snow cover, dust diminished planetary albedo, elevating temperatures above 6 km, hastening snow melting, which absorbed latent heat and increased the atmospheric water vapor content, consequently decreasing temperatures below 6 km. Surface meteorological element responses to dust varied significantly across different surface types. In the TD, 2 m temperature (T2) decreased by 0.4 °C during daytime, with the opposite nighttime variation. In the TP without snow cover, T2 was predominantly warming. In the snow-covered TP, T2 decreased throughout the day, with a maximum cooling of 1.12 °C and decreased PBL height by up to 258 m. Additionally, a supplementary simulation of a dust event from 17 June to 19 June 2016 further validated our findings. The meteorological elements response to dust is significantly affected by the dust concentration, thickness, and surface type, with significant day–night differences, suggesting that surface types and dust distribution should be considered in dust effect studies to improve the accuracy of climate predictions.