SCA Fracturing Mechanisms of Rock Mass and Application in Overhanging Roof Structure Fragmentation of Mine Goaf

During coal resource mining, hard roof mining is prone to causing rock-burst disasters because traditional blasting–cutting roof technology has the disadvantages of low efficiency and high cost. This article studies the theoretical basis and engineering application of fracturing technology with a static expansion agent (SCA). The influences of borehole diameter and spacing on the fracturing effect of a rock mass are studied through theoretical analysis and simulation. Rock mass models of a cantilever beam for a single rock layer and multiple layers were established, and the mechanical properties of the roof strata under three working conditions were analyzed. The research results show that the maximum annular stress value occurs along the drill hole wall between the adjacent drill holes, and the annular stress at the center line between two drill holes is the smallest. As the spacing between the holes increases, the annular stress at the center line decreases; however, the annular stress at the center of the drill line becomes larger with the increase in hole diameter. The degree of stress concentration increases sharply with the decrease in distance f from the borehole center to the free surface. Relative to the cantilever beam model of a single rock layer, the combined rock layers can effectively control the displacement and deformation of the cantilever roof. Based on the above research results, a drilling method with a 75 mm diameter and a 10° inclination angle is used, demonstrating that the suspended roof area can be reduced to below 20 m2 using the fracturing technology with a static expansion agent, allowing the roof strata to fall simultaneously during mining.