Highlighting real capacitor behavior in liquid ammonia of passivated n-InP by thin Polyphosphazene film

Semiconductor/liquid junctions exhibit distinctive electrochemical behaviors. This study investigates the passivation of lightly doped (10 15 cm −3 ) n-type indium phosphide (n-InP) in liquid ammonia. Under photoanodic conditions, a Polyphosphazene (PPP) film forms on the InP surface. The formation of PPP ultra-thin film was confirmed through X-ray photoelectron spectroscopy. Cyclic voltammetry revealed a progressive positive shift in the onset potential for photocurrent, indicating successful progressive passivation. Capacitance–voltage measurements showed a constant capacitance (≈ 1.3 μF.cm −2 ) over 400 mV after passivation, signifying the formation of a stable capacitor-like structure at the interface in a large potential domain. Cyclic voltammograms acquired at different scan rates demonstrated that the current was proportional to the scan rate, confirming the capacitive nature of the InP/PPP interface. The same interface capacitance was also quantified from the slope of the linear fit between the current and scan rate, showing that the PPP film acts as a dielectric layer with a fixed capacitance. This capacitor-like behavior leads the semiconductor in accumulation configuration from open circuit potential to lower potentials. To balance the electrical charges, the PPP should be positively charged in this range of potentials. The capacitance was used to determine the relative dielectric constant of the PPP film, which was found to be approximately 6.9. This value is consistent with that of polymeric materials exhibiting good insulating properties, further supporting the effective dielectric behavior of the PPP layer. This capacitor-like behavior alters the electrochemical response and stability of the InP/NH₃ Liq. interface, underscoring its potential for innovative electrochemical applications. • PPP formation leads to an enrichment of electrons on InP surface at Vocp. • A positive charge is brought by PPP/NH 3 Liq. interface at Vocp. • Capacitor behavior of InP/PPP/NH 3 Liq. interface is shown. • Determination of relative permittivity of ultra-thin PPP. • Capacitance deduced from impedance and cycle voltammetry.

Authors

Institutions

Publication Details

Journal
Electrochemistry Communications
Published
2025-04-15
DOI
https://doi.org/10.1016/j.elecom.2025.107935
Citations
1
Primary Topic
Semiconductor materials and interfaces
Type
article
Field-Weighted Citation Impact
1.25
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
article

Highlighting real capacitor behavior in liquid ammonia of passivated n-InP by thin Polyphosphazene film

Anne‐Marie Gonçalves, Gianluca Visagli, Arnaud Etchberry
1 citations
Electrochemistry Communications
Semiconductor materials and interfaces
1.25
article

Highlighting real capacitor behavior in liquid ammonia of passivated n-InP by thin Polyphosphazene film

Anne‐Marie Gonçalves, Gianluca Visagli, Arnaud Etchberry
article en
1 citations

Abstract

Semiconductor/liquid junctions exhibit distinctive electrochemical behaviors. This study investigates the passivation of lightly doped (10 15 cm −3 ) n-type indium phosphide (n-InP) in liquid ammonia. Under photoanodic conditions, a Polyphosphazene (PPP) film forms on the InP surface. The formation of PPP ultra-thin film was confirmed through X-ray photoelectron spectroscopy. Cyclic voltammetry revealed a progressive positive shift in the onset potential for photocurrent, indicating successful progressive passivation. Capacitance–voltage measurements showed a constant capacitance (≈ 1.3 μF.cm −2 ) over 400 mV after passivation, signifying the formation of a stable capacitor-like structure at the interface in a large potential domain. Cyclic voltammograms acquired at different scan rates demonstrated that the current was proportional to the scan rate, confirming the capacitive nature of the InP/PPP interface. The same interface capacitance was also quantified from the slope of the linear fit between the current and scan rate, showing that the PPP film acts as a dielectric layer with a fixed capacitance. This capacitor-like behavior leads the semiconductor in accumulation configuration from open circuit potential to lower potentials. To balance the electrical charges, the PPP should be positively charged in this range of potentials. The capacitance was used to determine the relative dielectric constant of the PPP film, which was found to be approximately 6.9. This value is consistent with that of polymeric materials exhibiting good insulating properties, further supporting the effective dielectric behavior of the PPP layer. This capacitor-like behavior alters the electrochemical response and stability of the InP/NH₃ Liq. interface, underscoring its potential for innovative electrochemical applications. • PPP formation leads to an enrichment of electrons on InP surface at Vocp. • A positive charge is brought by PPP/NH 3 Liq. interface at Vocp. • Capacitor behavior of InP/PPP/NH 3 Liq. interface is shown. • Determination of relative permittivity of ultra-thin PPP. • Capacitance deduced from impedance and cycle voltammetry.

Electrochemistry CommunicationsVol. 176
Centre National de la Recherche Scientifique (FR), Université de Versailles Saint-Quentin-en-Yvelines (FR), Université Paris-Saclay (FR), Institut Lavoisier de Versailles (FR)
Openalex Percentile: Top 22%
Semiconductor materials and interfaces
1.25
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.