Winter Wheat Tolerance to Clopyralid Applied in the Fall, Spring, or Fall Followed by Spring

Limited information exists on the sensitivity of winter wheat to clopyralid applied in the fall, spring, or sequentially [fall followed by (fb) spring] under Ontario environmental conditions. Six field experiments were conducted over two years (2023 and 2024) near Exeter and Ridgetown, Ontario, to evaluate the effects of clopyralid (100, 200, and 400 g ai ha-1) applied in the fall, spring, or sequentially (fall fb spring) on winter wheat injury, height, seed moisture content, and yield. No visible injury was observed at 1, 2, and 4 weeks after application with clopyralid applied in the fall, spring, or sequentially at the evaluated rates. Clopyralid applied in the fall at all rates caused no injury to winter wheat; in contrast, when applied in the spring clopyralid caused 3, 7, and 14% visible injury at 100, 200, and 400 g ai ha-1, respectively. Sequential applications of clopyralid (fall fb spring) resulted in 4, 9, and 17% visible injury at the same respective rates. Clopyralid application at 100, 200, and 400 g ai ha-1 in the fall, spring, or sequentially had no significant effect on winter wheat height or seed moisture content. Clopyralid applied at 100, 200, and 400 g ai ha-1 in the fall did not affect winter wheat yield. Clopyralid applied at 100 and 200 g ai ha-1 in the spring had no impact on yield, but when applied at 400 g ai ha-1, it reduced winter wheat yield by 19%. Sequential applications at 100 fb 100 and 200 fb 200 g ai ha-1 also had no significant effect on winter wheat yield, while the 400 fb 400 g ai ha-1 treatment reduced winter wheat yield by 17%. These results conclude that clopyralid applied in the fall caused no visible wheat injury and no decrease in wheat height or yield. Clopyralid, applied in the spring at 100 and 200 g ai ha-1 caused 3 and 7% visible wheat injury, respectively but no decrease in wheat height or yield. Clopyralid applied in the spring at 400 g ai ha-1 caused up to 17% visible wheat injury and reduced wheat yield by up to 19%. These results conclude that clopyralid at the label rate applied in the fall, spring, or sequentially has no adverse effect on winter wheat; however, where there is a spray overlap clopyralid can cause unacceptable wheat injury and yield loss.

Authors

Publication Details

Journal
Journal of Agricultural Science
Published
2025-04-09
DOI
https://doi.org/10.5539/jas.v17n5p21
Primary Topic
Insect and Pesticide Research
Type
article
Field-Weighted Citation Impact
0.00

Funders

Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
article

Winter Wheat Tolerance to Clopyralid Applied in the Fall, Spring, or Fall Followed by Spring

Nader Soltani, Peter H. Sikkema, Christy Shropshire
Journal of Agricultural Science
Insect and Pesticide Research
article

Winter Wheat Tolerance to Clopyralid Applied in the Fall, Spring, or Fall Followed by Spring

Nader Soltani, Peter H. Sikkema, Christy Shropshire
article en

Abstract

Limited information exists on the sensitivity of winter wheat to clopyralid applied in the fall, spring, or sequentially [fall followed by (fb) spring] under Ontario environmental conditions. Six field experiments were conducted over two years (2023 and 2024) near Exeter and Ridgetown, Ontario, to evaluate the effects of clopyralid (100, 200, and 400 g ai ha-1) applied in the fall, spring, or sequentially (fall fb spring) on winter wheat injury, height, seed moisture content, and yield. No visible injury was observed at 1, 2, and 4 weeks after application with clopyralid applied in the fall, spring, or sequentially at the evaluated rates. Clopyralid applied in the fall at all rates caused no injury to winter wheat; in contrast, when applied in the spring clopyralid caused 3, 7, and 14% visible injury at 100, 200, and 400 g ai ha-1, respectively. Sequential applications of clopyralid (fall fb spring) resulted in 4, 9, and 17% visible injury at the same respective rates. Clopyralid application at 100, 200, and 400 g ai ha-1 in the fall, spring, or sequentially had no significant effect on winter wheat height or seed moisture content. Clopyralid applied at 100, 200, and 400 g ai ha-1 in the fall did not affect winter wheat yield. Clopyralid applied at 100 and 200 g ai ha-1 in the spring had no impact on yield, but when applied at 400 g ai ha-1, it reduced winter wheat yield by 19%. Sequential applications at 100 fb 100 and 200 fb 200 g ai ha-1 also had no significant effect on winter wheat yield, while the 400 fb 400 g ai ha-1 treatment reduced winter wheat yield by 17%. These results conclude that clopyralid applied in the fall caused no visible wheat injury and no decrease in wheat height or yield. Clopyralid, applied in the spring at 100 and 200 g ai ha-1 caused 3 and 7% visible wheat injury, respectively but no decrease in wheat height or yield. Clopyralid applied in the spring at 400 g ai ha-1 caused up to 17% visible wheat injury and reduced wheat yield by up to 19%. These results conclude that clopyralid at the label rate applied in the fall, spring, or sequentially has no adverse effect on winter wheat; however, where there is a spray overlap clopyralid can cause unacceptable wheat injury and yield loss.

Journal of Agricultural ScienceVol. 17(5)
Grain Farmers of Ontario, Ontario Agri-Food Innovation Alliance
Openalex Percentile: Top 93%
Insect and Pesticide Research
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.