Can Non-Phase-Transformation Heat Treatments Improve the Strength Properties of Materials?

The article is the result of the question mentioned in its title, namely, whether heat treatments without phase transformation and pressing of parts can improve the physicomechanical properties of metallic materials and alloys. Starting from this hypothesis, the article analyzes the influence of non-phase change thermal treatment TT and plastic deformation (compression) on a steel used for the realization of components in the engineering industry, as presented in the specific standards SR EN-10025 and SR EN-10027. The results of the tensile tests and of the Vickers hardness tests on the specimens made of this material are presented. The results in terms of material ultimate stress σ_u, yield strength S_y, elongation δ, reduction in cross section ψ, as well as those obtained in the Vickers test are summarized in tabular or graphical form. From the research conducted by the authors of this work, it can be seen that the 0.5 × T_m-s (T_m-s-melting-solidifying temperature, K) heat treatment gives the best mix of properties: mechanical strength similar to that of the non-treated material, improved elasticity and ductility, but with a small, negligible reduction in hardness. The results are useful to support the activities of optimal selection of heat treatments and plastic forming for various engineering applications. Heat treatment without phase transformation is essential for improving the mechanical properties of materials used in engineering. This study investigates the impact of heat treatments and plastic deformation on S355J2+N steel, highlighting the increase in yield strength and improvement in ductility. The results show an increase of up to 15% in yield strength and an improvement in relative elongation by 2% for treatments at 0.5 × T_m-s, while hardness remains almost unchanged.