Concept of an Electromechanical Brake-By-Wire System for Battery-Electric Vehicles

<div class="section abstract"><div class="htmlview paragraph">Brake-by-wire systems have received more and more attention in the recent years, but a close look on the available systems shows, that they have not reached full by-wire level yet. Most systems are still using hydraulic connections between main cylinder and the brake calipers on at least one axle to ensure functional safety. Mostly, this is the front axle, since the front brakes have to convert more kinetic energy during braking manoeuvers. Electromechanical actuators are currently used for rear brakes in hybrid brake-by-wire applications solely, since a loss of the front brake calipers can lead to severe conditions and control loss of the vehicle during braking. Further, the higher mass of battery electric vehicles (BEVs) leads to much higher braking forces on both axles and to increased sizes of the electromechanical calipers. This article presents a concept for a brake-by-wire system for battery electric vehicles, which features electromechanical brake actuators on all corners and a redundant system architecture. Theoretically, the proposed system is capable to generate a braking intensity up to 70% for vehicles with a total mass of approximately 2.8 tons. Besides mechanical design of the actuator, the power electronics are taken into account too and their behavior is investigated through dedicated simulation.</div></div>