Physical Simulation Tests on Deformation and Instability of Composite Roof in Large-Section Coal Roadway Under Different Burial Depths

In response to the difficulty of controlling the layered composite roof of large-section coal roadways and the problem of slow excavation speed caused by unreasonable support parameter values, a dynamic staged control principle for surrounding rock based on “high-strength passive temporary support near the excavation face, combined with active support of rear bolts and anchor cables” is proposed by analyzing the evolution law of rock release stress under the spatial effect of excavation face. Based on the geological conditions of the 1211 (1) transportation roadway in Guqiao Coal Mine, a similar physical simulation test model was constructed to conduct experimental research on the bearing capacity and deformation instability mechanism of the surrounding rock of the layered-composite-roof coal roadway. The law of influence of staged support on the deformation and failure evolution of the surrounding rock was obtained. The research results show the following: (1) After loading above the model, the vertical stress on the roof increases rapidly in a “stepped” manner. After unloading the roadway excavation, due to the release of constraints on the roof above the roadway, the vertical stress on the roof rapidly decreases, especially in the temporary support area where the reduction in vertical stress on the roof is most significant. (2) As the vertical load increases, the displacement curve of the roof gradually evolves into a “V” shape. The farther away from the center of the roadway, the smaller the subsidence of the roof. When loaded to 54.45 kN, the subsidence of the roof increases, indicating that the development of roof delamination cracks is faster, and delamination occurs between 12 cm and 22 cm above the roof. (3) With the continuous increase of axial load, cracks first appear around the roof and slightly sink. Then, the cracks gradually expand and penetrate, causing instability and failure of the roadway roof. When the mining stress reaches 54.45 kN, the middle part of the roadway roof in the axial direction breaks, and the cracks penetrate, resulting in overall collapse.