Impact of Surface Tension and Surface Energy on Spray Coating Paper with Polysaccharide-Based Biopolymers

The demand for sustainable packaging has increased the interest in biopolymer coatings as alternatives to plastic-based barriers on paper and board. Alginate and chitosan offer promising barrier properties by improving gas barrier and grease resistance. However, their high viscosity at low solid contents presents challenges for uniform coatings, especially in possible future large-scale applications but also in existing research. This study evaluates spray coating, a non-conventional application method in the paper industry, to apply biopolymer coatings, an approach underexplored in previous studies. The effects of substrate surface energy and biopolymer surface tension on air permeability, grease resistance, and water vapor transmission were evaluated. Contact angle measurements showed that surface energy strongly influences the wetting behavior of these biopolymers, with hydrophilic substrates and lower-surface-energy liquids promoting better droplet spreading. This improved wetting resulted in better barrier performance at low application weights, further enhanced by surfactant addition. At higher application weights, surface energy had less impact on barrier properties. SEM imaging revealed drying defects at increased coat weights, affecting film integrity. These findings demonstrate the potential of spray coating as a scalable method for biopolymer application while highlighting the need for optimized drying conditions to enhance film uniformity and barrier performance.