Microstructural investigation into the damage mechanism of short pitch rail corrugation

• The continuous microstructural alterations of a corrugated rail sample are examined. • The corrugation damage mechanism is identified based on microstructural analysis. • Corrugation initiation is dominated by differential wear. • Corrugation growth involves both differential wear and plastic deformation accumulation. • Grinding depth is suggested to account for differential PDL thickness. Short pitch corrugation is a typical rail defect that lacks a thorough understanding and adequate root-cause solutions. This paper aims to identify the damage mechanism of short pitch corrugation through a microstructural analysis of a field rail sample. This sample made of R260Mn pearlitic steel was taken from a straight section of the Dutch railway network, and its geometry and surface hardness variation along the corrugation were measured and analyzed. Eleven specimens, including both corrugated and non-corrugated zones, were sectioned from the rail sample and continuously examined using light optical microscopy, scanning electron microscopy and micro-hardness testing. The results indicate that the corrugation damage mechanism can be categorized into three stages: (1) pre-corrugation, characterized by uniform wear and plastic deformation; (2) corrugation initiation, dominated by differential wear; and (3) corrugation growth, involving both differential wear and plastic deformation accumulation. The initiation and growth of corrugation both contribute to an inhomogeneous distribution of plastic deformation layer (PDL) in the rail subsurface, which follows an approximately sinusoidal pattern, matching the corrugation geometry in both wavelength and phase. Consequently, the hardness also varies in phase with the corrugation geometry, with higher hardness values at corrugation peaks. In the non-corrugation zone, the PDL and hardness show relatively small and irregular fluctuations. This study also provides meaningful insights into rail grinding, suggesting that grinding should account for differential PDL thickness to prevent corrugation reoccurrence due to subsurface material inhomogeneity.