Optimization of Mechanical and Dynamic Properties of Tread Rubber Using Fumed Silica and Hydration Processing

Fumed silica, a nanomaterial with a high specific surface area, excellent chemical stability, and electrical insulation, serves as an effective filler for rubber compounding. Compared to traditional carbon black, silica (SiO₂), the main component of fumed silica, improves the hardness and tear resistance of tread rubber, making it a viable substitute in some formulations. However, silica-filled compounds generally exhibit lower tensile properties and abrasion resistance than carbon black. Fumed silica, with its higher structural integrity, provides additional reinforcement points within natural rubber matrices, enhancing tensile strength and abrasion resistance. Studies demonstrate that replacing carbon black with an equivalent amount of fumed silica as the primary filler significantly improves tread rubber's hardness (by 20%) and 300% tensile modulus (by 14%) while also reducing rolling resistance and enhancing wet skid performance. Fumed silica's large specific surface area and low density (10-15% of conventional silica) make it challenging to use directly as a tread rubber filler due to dust formation and prolonged mixing times. This study developed a process combining fumed silica with deionized water, followed by drying and ball milling. This treatment reduces the material's volume, forming a cohesive gel that, upon processing, minimizes dust and significantly decreases mixing time and difficulty. The interaction between the hydroxyl (-OH) groups on the surface of fumed silica and water molecules likely results in hydrated silica. This interaction enhances surface polarity and forms a hydration layer, improving the hydrophilicity and dispersion of fumed silica in rubber matrices. This reduces the shear modulus difference (ΔG') between low and high strain, maintaining a consistent elastic modulus over a wide strain range. Such stability enables rubber to perform better under dynamic loads or in complex working conditions. The experimental results demonstrate that the hydration-ball milling process enhances the tensile strength of vulcanizates, improves the dispersion of fumed silica in rubber, strengthens the filler network, boosts dynamic performance, and enhances the wet skid resistance of tread rubber.