Assessment of the viscoelastic and multi-axial mechanical response of POM using hypoelastic and hyperelastic constitutive models

The mechanical behaviour of thermoplastics is strongly rate-dependent. One thermoplastic that is commonly used in industrial applications is polyoxymethylene (POM). In a previous paper (Mechanics of Time-dependent Materials, 2024, vol 28, p 43-63), the uniaxial tensile properties of POM were tested, and in the present study, those tests are complemented by compression tests, bending tests, and punch tests. The test data in this study can be divided into calibration data and verification data. The calibration experiments consist of both tensile and compression tests carried out in monotonic loading, stress relaxation, and zero-stress creep. Three-point bending and quasi-static punch tests are used as verification tests. Overall, the experiments showed good repeatability, and there was a low dispersion in the experimental results. The paper compares the performance of three constitutive models that have been developed for modelling these materials. Two hyperelastic models and one hypoelastic model are compared. The models are calibrated using the uniaxial data and then applied to the results from the more advanced tests. The material models are calibrated by utilizing commercially available optimization software. All models have the ability to model visco-elasticity. Two of the models are network models with three visco-elastic branches/legs/phases. These two models are built in a similar way with two main novelties. The first novelty is that the stiffness can vary with the elastic deformation (in contrast to a standard neo-Hookean and Hookean model). The second novelty is that the exponent of viscous relaxation can vary with viscous deformation. The third model is an Eulerian model, meaning that all state variables are defined in the current state of the material. Taken together, the models were able to describe the experimental results relatively well. It was concluded that they have different strengths and weaknesses. The hypoelastic model was able to describe the uniaxial calibration data best. On the other hand, this model became unstable at large deformations when simulating the punch tests. The two hyperelastic models could not model the zero-stress creep in the uniaxial tests but were able to predict the outcome from the punch tests quite well. It was clear from the simulations that further model development is needed in order to capture all aspects of the experimental results. • Compression testing of POM at different strain rates. • 3-point bending testing of POM at different strain rates. • Punch testing of POM plates at different strain rates. • Analysis of experiments using three constitutive models.