The critical role of the anode porous transport layer/catalyst layer interface of polymer electrolyte membrane water electrolyzers: A parametric analysis
Reducing the dependency of proton exchange membrane water electrolyzers (PEMWE) on precious metals, such as iridium (Ir), is necessary to develop a widespread green hydrogen system. This challenge requires a careful design of the interface between the anode porous transport layer (PTL) and the catalyst layer (CL). A comprehensive numerical analysis of relevant parameters that govern the behavior of the anode PTL/CL interface is presented. Calculations are also combined with an experimental characterization of the thickness and electrical conductivity of an unsupported CL as a function of Ir loading. The results show that the in-plane electrical resistance at the anode PTL/CL interface plays a critical role in cell performance. Reaching an acceptable electrical resistance at low Ir loading ( L Ir ≃ 0 . 1 mg Ir , cm − 2 ) can be accomplished through the incorporation of a micrometer-sized microporous layer (MPL) onto the PTL or the preparation of bimodal CLs with a secondary conductive phase. Further reduction of the Ir loading to the ultra-low regime ( L Ir ≲ 0 . 1 mg Ir , cm − 2 ) may require the use of nanometer-sized MPLs with unsupported CLs or micrometer-sized MPLs with bimodal CLs. Furthermore, the decline of the volume reactive area at ultra-low Ir loading needs a maximization of the exchange current density and the specific electrochemical surface area, and a decrease of the catalyst oxygen coverage factor in the anode CL. • A 2D parametric analysis of key factors of the anode PTL/CL interface is presented • In-plane CL electrical resistance at PTL interface plays a critical role on performance. • Low Ir loading ( 0 . 1 mg Ir , cm − 2 ) can be achieved with micrometer-sized MPL or bimodal CL. • Ultra-low Ir loading ( ≲ 0 . 1 mg Ir , cm − 2 ) can be reached with fine MPLs and bimodal CL. • Optimization of volumetric exchange current density and gas saturation is needed.
Authors
- Jack Todd Lang (ORCID: https://orcid.org/0000-0002-3060-0475)
- Yu Morimoto (ORCID: https://orcid.org/0000-0001-9140-1691)
- Pablo A. García‐Salaberri (ORCID: https://orcid.org/0000-0002-3918-5415)
- Iryna V. Zenyuk (ORCID: https://orcid.org/0000-0002-1612-0475)
- Hung-Ming Chang
- Nausir Firas (ORCID: https://orcid.org/0000-0001-6313-0206)
- Hasan Shazhad
Institutions
- Universidad Rey Juan Carlos (ES)
- University of California, Irvine (US)
- Universidad Carlos III de Madrid (ES)
Publication Details
- Journal
- Chemical Engineering Journal
- Published
- 2025-02-26
- DOI
- https://doi.org/10.1016/j.cej.2025.160722
- Citations
- 11
- Primary Topic
- Hybrid Renewable Energy Systems
- Type
- article
- Field-Weighted Citation Impact
- 5.85
Funders
- Agencia Estatal de Investigación