A New Conceptual Design of Twisting Morphing Wing

This research aims to enhance the performance of unmanned aerial vehicles (UAVs) by investigating the impact of twisting wingtip (TWT) on UAVs' wing aeroelastic and structural behavior using MATLAB and ANSYS simulations. The study focuses on a simplified twisting wingtip design and its aeroelastic effect. This study includes both static and dynamic aeroelastic phenomena. Previous research has primarily focused on only flutter speed while neglecting divergence speed and lift-effectiveness in design results. Numerical and experimental validation underscores the model's fidelity and its practical applicability. The TWT is designed to exhibit a predominant torsional mode using a guide mode preference technique. The design results reveal that the twist morphing wing improves structural and aeroelastic performance due to its unique twisting deformation capabilities. Furthermore, this research contributes fundamental insights into a specific twist morphing wing concept, highlighting its potential to enhance UAV performance through twisting wingtip technologies. The torsional mode can be predetermined using the guide mode preference technique. Notably, the divergence speed analysis confirms that the twisting shaft position should not exceed the aerodynamic center, which is located at 0.2103 of the chord length. This serves as the theoretical foundation for the TWT design in this study. The adjustment of the TWT's twisting angle is confirmed to provide optimal divergence speed improvement within a range of 0% to 27.7%. Additionally, the relative aeroelastic efficiencies indicate that the highest lift effectiveness is 0.68% at a twisting angle of 30°, following an exponential relationship, which can be further extended to aircraft control laws. However, the relative efficiency of flutter speed is not significantly improved by the TWT, showing only a marginal improvement of 0% to 1.84% when twisting up and down, in accordance with previous research findings.