Influence of Waste Catalyst Surface Characteristics on High-Temperature Performance and Adhesion Properties of Asphalt Mortar

The incorporation of waste fluid catalytic cracking (FCC) catalysts (WFCs) into asphalt pavements represents an effective strategy for resource utilization. However, the influences of the composition of the waste catalyst and its surface characteristics on the performance of asphalt mortars are still unclear. Herein, five WFCs were selected as powder filler to replace partial mineral powder (MP) to prepare five asphalt mortars. The diffusion behaviors of asphalt binder on the components of WFCs were investigated based upon molecular dynamic simulation, as was the interfacial energy between them. The adhesion work values between asphalt and WFCs were evaluated based upon the surface free energy theory. A dynamic shear rheology test and multiple stress creep recovery test on the WFC asphalt mortar were also conducted. Furthermore, the gray correlation analysis (GCA) method was employed to analyze the correlation between the diffusion coefficient and interfacial energy with the performance of WFC asphalt mortar. The results showed that the asphalt exhibited a low diffusion coefficient and high interfacial energy with the alkaline components of WFCs. The adhesion work values between asphalt and WFCs are higher than those with MP. The addition of WFCs can enhance the anti-rutting property of asphalt mortar significantly. Among the five WFCs, 2# exhibited the best improvement effect on the anti-permanent deformation ability of asphalt mortar, which may be due to its large specific surface area and moderate pore width. The GCA results suggest that the diffusion coefficient and interfacial energy strongly correlated with the performance of asphalt mortar, with an order of adhesion > permanent deformation resistance > rutting resistance. This study provides both theoretical and experimental support for the application of WFCs in asphalt materials.