The Effect of High-Pressure Hydrostatic Extrusion on Mechanical Properties of Printed with Fused Deposition Modeling PLA and PLA-Diatomaceous Earth Composites

Three-dimensional printing enables rapid prototyping, customization, and on-demand production. Polylactide is a popular biopolymer filament used in 3D printing. However, due to its brittleness and low mechanical strength, it often needs to be reinforced with filler particles. Diatomaceous earth shows great potential as a filler material due to its abundant and natural occurrence, biocompatibility, and environmental friendliness, as well as its excellent mechanical properties. Cold hydrostatic extrusion was used to improve the compressive strength of 3D-printed parts. Both neat and reinforced with 10% diatomaceous earth filaments were used to 3D print cylindrical billets, followed by post-processing using hydrostatic extrusion. X-ray microtomography showed a significant reduction in total and open porosity and average pore size, from ~20 µm to less than 10 µm in the Polylactide (PLA) and Diatomaceous (DE) composite. Compression tests showed a significant improvement in the compressive strength of PLA from ~60 MPa to ~100 MPa, while PLA with DE achieved an impressive almost twofold increase to 80-120 MPa. This was attributed to a reduction in pore size, as well as pore closure, which mitigates crack initiation in semi-brittle PLA. In addition, it has been proposed that hydro extrusion-induced structural rearrangement is an important strengthening factor.