Accurate Simulation of Flow through Dipping Aquifers with <scp>MODFLOW</scp> 6 Using Enhanced Cell Connectivity

In simulations of groundwater flow through dipping aquifers, layers of model cells are often "deformed" to follow the top and bottom elevations of the aquifers. When this approach is used in MODFLOW, adjacent cells within the same model layer are vertically offset from one another, and the standard conductance-based (two-point) formulation for flow between cells does not rigorously account for these offsets. The XT3D multi-point flow formulation in MODFLOW 6 is designed to account for geometric irregularities in the grid, including vertical offsets, and to provide accurate results for both isotropic and anisotropic groundwater flow. A recent study evaluated the performance of the standard formulation and XT3D using a simple, synthetic benchmark model of a steeply dipping aquifer. Although XT3D generally improved the accuracy of flow simulations relative to the standard formulation as expected, neither formulation produced accurate flows in cases that involved large vertical offsets. In this paper, we explain that the inability of XT3D to produce accurate flows in the steeply dipping aquifer benchmark was not due to an inherent limitation of the flow formulation, but rather to the limited cell connectivity inherent in the most commonly used discretization packages in MODFLOW 6. Furthermore, we demonstrate that XT3D is able to produce the expected accuracy when adequate cell connectivity is introduced using MODFLOW's unstructured grid type and the aquifer is discretized vertically using at least two model layers.