Abstract 235: Cyclic Aspiration in Mechanical Thrombectomy: Influencing Factors and Experimental Validation

Introduction/Purpose Mechanical thrombectomy is a fundamental intervention for acute ischemic stroke treatment. While conventional techniques are effective, cyclic aspiration (CyA) shows potential for better recanalization rates. We aim to investigate factors affecting CyA and compare them with static aspiration (StA). Materials/Methods StA setup consisted of an aspiration pump connected to pressure transducer. CyA was tested with five setups: single solenoid valve with air+saline (1) or saline alone (2) as aspiration medium; two solenoid valves with air+saline (3) as aspiration medium; complete air removal and saline feeding (4); pressurized saline feeding (5). To assess the efficacy of clot ingestion, the pressure transducer was replaced with a distal aspiration catheter. Moderately stiff clot analogs (15 mm) were used to investigate the ingestion quantified as clot relative weight loss. Additionally, the aspiration flow rate was assessed for each setup. Results With CyA setup 1, the amplitude of the achieved negative pressure waves declined with increasing frequencies but progressively increased with each subsequent iteration, achieving a maximum amplitude of 81 kPa for setup 5 at 1Hz. Relative clot weight loss was significantly higher with setup 5 at 5Hz than with StA (100% vs. 37,8%; p=0.05). Aspiration flow rate was lower with CyA than with StA (setup 5 at 5Hz: 199,8ml/min vs. StA: 311ml/min; p<0.01). Conclusion Cyclic aspiration with the appropriate setup may represent an encouraging innovation in mechanical thrombectomy, offering a promising pathway for improving efficacy in clot ingestion and recanalization. The observed benefits warrant confirmation in a clinical setting.