Surface Hydrophilic Modification of Polypropylene by Nanosecond Pulsed Ar/O2 Dielectric Barrier Discharge

Polypropylene (PP) membranes have found diverse applications, such as in wastewater treatment, lithium-ion batteries, and pharmaceuticals, due to their low cost, excellent mechanical properties, thermal stability, and chemical resistance. However, the intrinsic hydrophobicity of PP materials leads to membrane fouling and filtration flux reduction, which greatly hinders the applications of PP membranes. Dielectric barrier discharge (DBD) is an effective technique for surface modification of materials because it generates a large area of low-temperature plasma at atmospheric pressure. In this study, O₂ was added to nanosecond pulsed Ar DBD to increase its reactivity. Electrical and optical diagnostic techniques were used to study the discharge characteristics of the DBD at varying O₂ contents. The uniformity of the discharge was quantitatively analyzed using the observed discharge images. Water contact angle measurements were used to assess the surface hydrophilicity of polypropylene. The surface morphology and chemical composition of the PP materials before and after treatment were analyzed using field emission scanning electron microscopy (FE-SEM), atomic force microscopy (AFM), Fourier-transform infrared spectroscopy (FTIR), and X-ray photoelectron spectroscopy (XPS). The results show that the moderate addition of O₂ enhances surface hydrophilicity and the uniformity of the modification. By increasing the O₂ addition from 0% to 0.1%, the average power increased from 4.19 W to 5.79 W, and the energy efficiency increased from 17.78% to 21.51%. The water contact angle of the DBD-treated PP showed a tendency to decrease and then increase with increasing O₂ content, with the optimum O₂ addition determined to be 0.1%. Under this condition, the water contact angle of the PP surface decreased by 31.88°, which is 52.31% lower than the untreated surface. O₂ increases the number of oxygen-containing polar groups (-OH, C=O, and O-C=O) on the surface of the material, and deepens and densifies the grooves on the surface of the PP material, resulting in an increase in the hydrophilicity of the PP surface.