Transformations in the Ti-6Al-4V Alloy Studied Using Dilatometry Supported by Acoustic Emission

This paper presents the results of research on the kinetics of transformations in the two-phase (α + β) Ti-6Al-4V alloy. The transformation start and end temperatures during heating at different rates were determined using a dilatometer. A modified dilatometer was employed, equipped with an acoustic emission measurement apparatus and software enabling the assessment of sample dimensional changes during heating and cooling. The results were obtained in the form of dilatometric curves. Additionally, the occurrence of the transformation was confirmed by acoustic emission signals. In the study of the Ti-6Al-4V alloy, acoustic emission refers to the application of this non-destructive technique to monitor the alloy's behavior during thermal processes. As the temperature increased, regardless of the heating rate, the α→β transformation was observed to occur after exceeding 900 °C. Within the transformation range, acoustic emission signals were recorded. Moreover, it was found that the applied research methods enabled the identification of signal components originating from the transformation. The application of acoustic methods in the analysis of phase transformations opens new possibilities for their use in industry.