Finite element analysis method as an alternative for furniture prototyping process and product testing

<p>In the current furniture industry, making furniture goes through many steps. There are ordering materials, designing, building a prototype, and testing samples. This process is considered quite complex, requiring significant costs, and lengthy production time. The application of finite element analysis (FEA) can be a solution to simulate the furniture manufacturing process. Objective of this research was to determine FEA could substitute making and test prototype furniture thereby saving costs and time. This method utilizes ANSYS 18.1 software for more accurate and rapid calculations, incorporating load variables of 400 N, 600 N, 800 N, and 1,000 N, along with gravitational acceleration of 10 \frac{m}{s^2}. The research evaluates the difference (expressed as a percentage) between the results obtained from simulations and those obtained directly from experiments, considering maximum equivalent stress, maximum principal stress, and total deformation values. The final step involves comparing the simulation with direct testing in terms of cost and time. The research results show an average error factor of 5% across all aspect. In terms of cost, the method can save 1,807 USD and reduce production time by up to one month. From these findings, it can be concluded that the process of prototyping and sample testing can be replaced using the finite element method.</p>