Experimental and numerical investigation into rolling contact fatigue crack initiation on the V-Track test rig

This study experimentally and numerically investigated wheel–rail rolling contact fatigue (RCF), focusing on the initiation mechanisms of head check (HC). The experimental study was conducted using V-Track, a scaled test rig developed at TU Delft that is able to simulate real-life wheel–rail contact with controllable contact geometries and loading conditions. Ratcheting and HCs were generated on the V-Track rails with wheel–rail frictional rolling contact loading for up to 60,000 cycles. Rail samples with HCs were then examined with a microscopic analysis focusing on the R260MN steel grade. The boundary element method (BEM) and finite element method (FEM) were then applied to calculate wheel–rail contact-induced stress states in and below the rail surface under the same contact conditions as the experiment. The rail surface shear stresses calculated with BEM exhibited a strong correlation to the ratcheting observed within the rail running band in the microscopic analysis. Moreover, the plastic flows and cracks outside the running band identified by the microscopic analysis were correlated to the rail surface stresses, especially outside the contact patch, and subsurface stresses calculated with FEM: the results suggested that the accumulation of residual stresses could also contribute to plastic flow and the consequent initiation of cracks outside the running band. • Generate ratcheting and HC cracks under real-life contact conditions in the V-Track. • Examine plastic flow patterns and HC cracks of rail steel in a microscopic analysis. • Correlate BE and FE simulated contact stresses with observed plastic flow patterns. • Both experiment and FE simulation show plasticity may also occur outside running band.