Completion and Stimulation Design Evolution in Tight Chalk Formations in Offshore Norway

Summary Lower completion and acid stimulation designs for low-permeability chalk formations in a series of North Sea fields were modified from historical/legacy approaches to improve well performance for both production and injection purposes. The modifications included (1) a stimulation change from high-rate matrix acidizing to acid fracturing and (2) optimization of ball-activated sliding sleeve designs. The improvement in well performance was validated by actual productivity comparisons to offset wells. Further improvements are being developed for future extended reach wells. A ball-activated sliding sleeve completion was chosen for a new series of improved horizontal well completions. Sleeve spacing, the number of sleeves, and port sizes were subsequently optimized for targeted stimulated lateral lengths by pipe flow modeling and limited-entry design methods. Optimization of acid fracturing designs was achieved after incorporating critical findings from various laboratory tests including rotating disk tests, acid-etched fracture conductivity tests, and gel shear history simulator tests. The new acid fracturing treatment designs were generated with the help of numerical simulations that were continuously fine-tuned based on new observations made during treatments and rigorous analysis of bottomhole injection pressures during the treatment. As a result of the lower completion design optimization process, different-size nozzles were introduced into the sliding sleeves to treat up to five sleeves per stimulation stage with effective, limited-entry, fluid diversion. This allowed (1) use of available pumping weather windows effectively in the often-challenging North Sea offshore environment, (2) reducing or eliminating time-consuming wireline perforation runs, and (3) limiting acid exposure to mitigate ball/seat zonal isolation loss events (i.e., dissolvable balls were not always compatible with acid). The new and improved acid fracturing design enabled a reduction of the number of gel/acid cycles from five to three, which reduced stimulation cost without losing stimulation effectiveness. The new design also resulted in productivity enhancements depending on the well location within the structure. The largest performance improvement was observed in wells that were placed farther downflank, where stronger reservoir rock and lower permeabilities were found. These wells required a more intensive acid fracturing treatment to generate economical and sustainable production rates. Finally, wells that used the new stimulation techniques also tended to require a lower restimulation frequency. This type of analysis work has not been presented previously and it optimizes lower completion for acid fracturing stimulation on a well-by-well basis. Further improvement is expected as stimulation designs and completion technology continue to evolve.