Investigations into the residual multipath errors of choke-ring geodetic antennas on GNSS carrier-phase measurements

Abstract For about three decades, the Global Navigation Satellite System (GNSS) has been used for high-precision positioning in scientific and engineering applications, such as deformation monitoring for seismicity and volcano eruption. Such high-precision positioning applications require millimeter-level positioning accuracy. There are many man-made and natural reflective surfaces near the GNSS receiving antennas. GNSS signals can be reflected and then arrive at the GNSS antenna. The multipath effect occurs when the direct signal is mixed with the reflected signal at the GNSS receiver. Choke-ring antennas are designed to mitigate the multipath effect of reflected signals from below the horizontal plane of the GNSS receiving antenna. Moreover, GNSS receiving antennas at network/permanent stations are usually installed on tall pillars or monuments to prevent multipath from “ground” reflected signals. However, part of the reflected signals can still arrive at the GNSS antenna center and cause multipath errors in GNSS measurements. How much can the multipath effect be on the real-time GNSS-measured displacements in studies on seismicity and volcano eruption? This work investigates the below-the-horizon multipath effect of choke-ring antennas on GNSS carrier-phase measurements. Here we show the differenced carrier-phase multipath errors of two commonly used GNSS antennas at the International GNSS Service (IGS) tracking stations can reach 8 mm, the maximum, with the mean and SD in a few millimeters at the 95% confidence level. The findings of this work should be applicable to other choke-ring antennas with similar architecture.