Enhanced wear resistance, hydrophobic properties and corrosion resistance of plasma electrolyte oxidation coatings on Ti6Al4V alloys via addition of ZrO2 nanoparticles

Nanocomposite-coatings were fabricated on the Ti6Al4V titanium alloy plates via plasma electrolyte oxidation (PEO) with the addition of ZrO 2 nanoparticles (NPs), followed by low surface energy modification. Effects of ZrO 2 NPs concentrations on microstructure, adhesive strength, wear resistance, hydrophobic property and corrosion resistance of the PEO coatings were investigated, and corresponding influence mechanisms were revealed. The dual-layered nanocomposite-PEO coatings consisting of anatase, rutile, TiP 2 O 7 , m -ZrO 2 , t -ZrO 2 , ZrTiO 4 and Zr 3 (PO 4 ) 4 were formed, and ZrO 2 NPs were incorporated into the coatings via both inertia and reactive modes. Both the average pore size and porosity were reduced with ZrO 2 NPs addition. The adhesive strength of the PEO coatings was promoted via the addition of ZrO 2 NPs. An enhancement in wear resistance was achieved for the PEO coatings with ZrO 2 NPs due to the lower COF, higher microhardness and denser microstructure than that without NPs addition. The hydrophobic property was enhanced for the low surface energy modified PEO coatings with ZrO 2 NPs. A significant enhancement in the corrosion resistance was achieved for the PEO coatings with the addition of ZrO 2 NPs. The PEO coatings with ZrO 2 NPs in 6 g/L exhibited a higher corrosion inhibition efficiency and a higher charge transfer resistance than that in other concentrations and without ZrO 2 NPs addition, respectively. The enhancement in corrosion resistance for the PEO coatings with ZrO 2 NPs in 6 g/L were due to the formation of corrosion-resistant phases including ZrO 2 and ZrTiO 4 , and denser microstructure with better hydrophobic properties compared with that in other concentrations.