Regulation of sintering procedure on property of DLP‐printing SiO <sub>2</sub> –Al <sub>2</sub> O <sub>3</sub> ceramic: Key of cristobalite precipitation
Abstract In this work, alumina was selected as the second phase reinforced fused quartz ceramics and SiO 2 –Al 2 O 3 composite ceramics were fabricated via digital light processing (DLP) 3D‐printing. The effect of the sintering procedure on the mechanical and dielectric properties of SiO 2 –Al 2 O 3 composite ceramics were investigated in detail. The results show that the amount of cristobalite precipitation is the key factor affecting the properties of composite ceramics. The amount of cristobalite precipitation in composite ceramics could be controlled effectively by adjusting the heating rate, holding time, and sintering temperature. The sintering procedure is set as the heating rate of 4°C/min, sintering temperature of 1200°C, and holding time for 2 h, the flexural strength of SiO 2 –Al 2 O 3 composite ceramic is 47.13 MPa, dielectric constant ranges from 2.90 to 2.97, and the tangent of loss angle is less than 0.041. SiO 2 –Al 2 O 3 composite ceramics with high flexural strength and low dielectric constant were obtained by sintering procedure screening and optimization.
Authors
- Yu Pan (ORCID: https://orcid.org/0009-0000-4995-0689)
- Xiang Zheng (ORCID: https://orcid.org/0000-0002-8727-376X)
- Wenbo Li (ORCID: https://orcid.org/0000-0002-7432-0213)
- Jian Chen (ORCID: https://orcid.org/0000-0002-5947-5604)
- Yongsheng Liu
- Yijiang Zeng
- Yejie Cao
Institutions
- National University of Defense Technology (CN)
- Northwestern Polytechnical University (CN)
Publication Details
- Journal
- International Journal of Applied Ceramic Technology
- Published
- 2024-12-11
- DOI
- https://doi.org/10.1111/ijac.15005
- Citations
- 1
- Primary Topic
- Additive Manufacturing and 3D Printing Technologies
- Type
- article
- Field-Weighted Citation Impact
- 0.20
Funders
- National Key Research and Development Program of China