Study of Microstructure and Mechanical Properties by Torsional Behavior in Axial Closed Die Rolling Forming

The impact of the torsional component on the microstructure and mechanical characteristics of a titanium alloy is examined in this work using a combination of numerical simulation and experimental validation. During the axial closed die rolling (ACDR) forming, the combined effects of compressive and torsional deformation cause a significant increase in the specimen’s cumulative strain. The specimen’s shear strain changes most significantly at the height of H/2. The α-phase has a greater propensity to slip on the conical surface, followed by the cylindrical surface, according to SEM and EBSD analyses. The basal surface has the highest resistance to slip. The formation of a fine isometric α-phase occurs when the compressive component causes the α-phase to become more prone to breakage and fracture. A larger α-phase will form because of the torsional component’s influence, which increases the likelihood that the α-phase will slip and exhibit bending and twisting. With a difference in strength of less than 1 percent and a difference in plasticity between the tangential and radial directions of less than 5 percent, the mechanical properties of the TC11 disks formed by the ACDR show a greater degree of isotropy. The specimens show a tough fracture mode, with radial performance outperforming tangential performance, according to fracture morphology analysis.